Download Macro Station Users Manual
Transcript
UMAC MACRO and MACRO Stack User Manual • • • • Station node-specific variables MI910 - MI939 configure hardware for the machine interface channels associated with specified MACRO node by SW1 For stack axis-interface boards, appropriate ACC-8x breakout boards or equivalent for Station JMACH connectors provide easy wiring interface to external devices. For UMAC (“pack”) axis-interface boards, breakout connectors are integral to the boards. Wiring between breakout connectors and external devices provides physical connection. 2. Mapping the 3U MACRO Station’s machine interface channels to the Station’s MACRO motor node registers: • • • Station SW1 switch setting controls mapping of output commands and flags between machine interface channels and nodes Station Encoder conversion table (MI120-MI151) and Motor x variables MI10x control mapping of feedback position from machine interface channels to Station MACRO nodes Station Motor x variables MI11x control mapping of power-on absolute feedback position to Station MACRO nodes Mapping Machine Interface Channels to MACRO Nodes Machine Interface Channel x Registers Output A DAC, PWM Node n / Channel x mapping is determined by station SW1 setting MACRO IN 0 1 2 Output B DAC, PWM Output C PFM, PWM Control AMP Enable 3 Command Registers 3 Feedback Registers PMAC Node n Registers MACRO OUT 0 1 2 Status Flags ADC B Current Feedback Signals ADC A MI10x Station Encoder Conversion Table MI120 - MI151 Encoder Position Feedback Signals 3. Mapping the 3U MACRO Station’s MACRO motor node registers to the PMAC2’s [Turbo PMAC2’s] MACRO motor node registers • • • • • 4 Connection of the PMAC2 and MACRO Station in a common ring PMAC2 MACRO cycle frequency control PMAC2 Ultralite I992 and I997 [Turbo:I6800, I6801] PMAC2 (non-Ultralite) I900 and I901 [Turbo I7000, I7001, or I7200, I7201] PMAC2 I995 MACRO Master Type [Turbo: I6840, I6890, I6940, I6990] 3U MACRO Station Setup Overview