Download COMPASS-1 - ADCS

Transcript
Controlling Test
Figure 9-9: Excited coil during oscillation
9.1.5 Results
The test coils are labeled with increasing roman numbers, starting with the produced
coils from the beginning of the coil production for this project.
The moment of inertia is determined separately for every coil with the CAD software
Catia V5. For these determinations the average exterior area and the volume of every
coil is held constant as A= 5205 mm² or 3524 mm³. Four magnetorquers are tested, each
with a different number of turns. Considered a constant volume for each magnetorquer,
the different number of turns results in different volume densities, which are considered
in the moment of inertia determinations with the CAD software. The results are
explained in detail in coil X. The remaining results are analyzed in an analogous
manner. At the end of this chapter the results of all coils are presented.
5205 mm²
Figure 9-10: Magnetorquer
Figure 9-11: Average exterior area
61