Download Manual - Amazon Web Services

If RS-232 of the meter is under print-only mode, the meter will print out the
measured data when the measurement cycle is completed. The format of printed
data will be shown as one of the following:
1. <Measurement Data> + <CR> <LF>
for only primary display mode is enabled, or
2. <Measurement Data #1>, <Measurement Data #2> + <CR> <LF>
for both primary display and secondary display mode are enabled
6-5 Instructions of Command Sets
6-5-1 Key Commands
Table 6-3. Descriptions for Key Commands
Command
Equivalent Keystroke on the front panel
K1
Press
Vdc
key
K2
Press
Adc
key
K3
Press
Vac
key
K4
Press
Aac
key
K5
Press
Ω
K6
Press Diode key
K7
Press
K8
Press AUTO key
K9
Press
key
K10
Press
key
K11
Press MinMax key
K12
Press
Hold
key
K14
Press
REL
key
K15
Press
Shift
key
K16
Press
2nd
key.
K17
Press
Vdc
and
Vac
keys simultaneously
K18
Press
Adc
and
Aac
keys simultaneously
K19
Press
Shift
key
Hz
key
then
keys on the front panel.
(Increasing the intensity of VFD display)
K20
Press
Shift
then
keys on the front panel.
(Decreasing the intensity of VFD display)
53