1
Download PT2100 User Guide
Transcript
PT2100 8” TELEPROMPTER 5 Attach Part-J to Part-N. (2 x Part-D and 4 x Part-H are needed in this step) Part-J 6 Attach Part-P to the assembled parts. (2 x Part-D and 4 x Part-H are needed in this step) Part-P Part-N 7 Attaching assembled Part-K, assembled Part-P and your camera together. Washer (Not included) ikancorp.com ** Some cameras may require an extra spacer, such as a washer, in order to fit snugly. Part-F or Part-G (depends on your camera) > Secure your camera on Metal Bracket > Slide back in the Metal Bracket with your camera attached, and tighten all screws > Loosen the screws to allow them pass through the 8” T-Slot’s channels on both sides Metal Bracket ikancorp.com > Loosen the screws and slide out the Metal Bracket through the channels 3903 Stoney Brook Dr. Houston TX 77063 | +1.713.272.8822 | www.ikancorp.com | [email protected] | © 2009 ikan Corporation. All right reserved.
