Download BlueNRG, BlueNRG-MS stacks programming guidelines

Transcript
Design an application using BlueNRG, BlueNRG-MS ACI APIs
PM0237
#endif
/* Enable the acceleration characteristic client descriptor configuration
for notification */
ret = aci_gatt_write_charac_descriptor (conn_handle,
handle_value /* handle for acceleration
client descriptor
configuration */
0x02,
/* attribute value
length */
0x0001, /*
attribute value:
1 for notification */
);if (ret != BLE_STATUS_SUCCESS) PRINTF("Failure.\n")}
Once the characteristics notification have been enabled from the GAP Central, the GAP
peripheral can notify a new value for the free fall and acceleration characteristics as follows:
tBleStatus ret;
uint8_t val = 0x01;
uint16_t service_handle_value;
uint16_t charac_handle_value;
#ifdef BLUENRG_MS
service_handle_value = 0x000C;
charac_handle_value = 0x000D;
#else /*
service_handle_value
= 0x0010;
charac_handle_value = 0x0011;
#endif
/* GAP peripheral notifies free fall characteristic to GAP central*/
ret = aci_gatt_update_char_value (service_handle_value , /* acceleration
service handle */
charac_handle_value, /* free fall characteristic
handle */
0, /* characteristic
value offset */
0x01,/* characteristic value
length*/
&val, /* characteristic value */ );
ret = (accServHandle, freeFallCharHandle, 0, 1, &val);
if (ret != BLE_STATUS_SUCCESS) PRINTF("Failure.\n")}
tBleStatus ret;
80/97
DocID027104 Rev 3