Download NXP application package

58 • vacon
functional description
Through a manual command, the axis is carried out to zero (manual commands are enabled by
P2.8.11.2 = 1). The trigger pulse controls the cutting stroke (P2.8.11.3 = Position 000) and immediately after (with no dwell, P2.8.11.4 = 0, and without a new trigger pulse, P2.8.11.5 = 1 Auto) the axis
is carried out to zero and repositioned to start the next cutting stroke sequence (P2.8.11.6=5 requires homing and P2.8.7.8 = 1 forces repetition of calibration cycle prior to homing). The sequence
is finished because P2.8.11.9 = 0. The subsequent cutting stroke depends on a new trigger pulse because P2.8.11.8 = 0 Normal (on trigger front the execution is redirected to the first command of the
new cycle as the third command has not been programmed).
Tel. +358 (0)201 2121 • Fax +358 (0)201 212 205
6