Download IntesisBox_PA-AC-KNX.. - Intesis Software, S.L.

Transcript
IntesisBox® KNX - Panasonic A.C. (Etherea line)
User's manual r3 eng
 Decreasing step
This parameter lets select the decreasing step value (in %) that will be sent for a
long operation.
 Short/long operation limit (x100ms)
This parameter lets introduce the time period difference for the short and the long
operation.
 Cycl. send. period in long oper. (x100ms)
This parameter lets configure a time (in seconds) for the cyclical sending of a long
operation.
o
When “Shutter/Blind” is selected the communication objects and new parameters for
the Input “x” will appear as shown below.
Figure 4.45 Parameter detail
 Send telegram after bus recovery
This parameter lets select if the Binary Input “x” will send a telegram, or not, after a
bus recovery and the type of telegram sent (if enabled).
 When “No action” is selected, no telegram will be sent after a bus recovery.
 When “Move Up” is selected, the binary input will send a telegram with a
“0” value after a bus recovery. Also a new parameter will appear (see below).
 When “Move Down” is selected, the binary input will send a telegram with a
“1” value after a bus recovery. Also a new parameter will appear (see below).
Figure 4.46 Parameter detail
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
51 / 66