Download FileDirector Enterprise Manager

Transcript
FileDirector Enterprise Manager
Transferring document responsibility
If a document is created on a designated replication server, the id of this server
(HomeSN) is assigned to it. This server id is used to identify the owner of the
original document. In some cases it may make sense to transfer the document
responsibility. To transfer the id of the document to the target server, the option
“transfer document responsibility” needs to be selected before the replication
process starts. After transferring the responsibility, the documents can be edited
on the target server without an online connection to the original server.
Example:
A service provider scans documents for a customer. These documents are going
to be transferred to the customer’s server later on. The customer should be able
to work with the documents as if they were scanned in-house; no connection to
the server of the service provider is going to be established for this.
For this scenario the service provider needs a replication licence and starts the
replication scheduler on the customer‘s server after scanning in. In order to do so
the server of the service provider needs to be familiar with the customer’s server.
If the responsibility for the documents is transferred with the documents to the
customer’s server, the customer can work self-sufficient.
Replicate documents when checking in
This option has to be set, if documents should be replicated when checking in. In
this case the scheduler is ignored and the documents are immediately checked in.
Even if the remote server is offline, the documents are added to the “Sync” table.
They will be replicated later, with the replication scheduler.
Documents for replication schedule
This option is used for subsequent replication. The replicated documents can be
restricted by state and date.
Status
Document an be marked for replication
All documents
Never replicated documents
Documents for which a prior replication failed
Mark means that the documents are written in the table "Sync", and therefore a
list is compiled of the marked documents
The documents shall not automatically in the "Sync" table written when configured
to connect to the Cabinet and has been assigned. Once the target server is aware
that the document will automatically check the table marked for synchronization.
The next time the scheduler runs, the documents are replicated.
Cabinets
Page 79