Download USER`S MANUAL

Transcript
S3F84UA/F84U8_UM_REV1.10
INSTRUCTION SET
BITS — Bit Set
BITS
dst.b
Operation:
dst(b)
←
1
The BITS instruction sets the specified bit within the destination without affecting any other bits in
the destination.
Flags:
No flags are affected.
Format:
opc
dst | b | 1
Bytes
Cycles
Opcode
(Hex)
Addr Mode
dst
2
4
77
rb
NOTE: In the second byte of the instruction format, the destination address is four bits, the bit address 'b'
is three bits, and the LSB address value is one bit in length.
Example:
Given: R1
BITS
R1.3
=
07H:
→
R1
=
0FH
If working register R1 contains the value 07H (00000111B), the statement "BITS
three of the destination register R1 to "1", leaving the value 0FH (00001111B).
R1.3" sets bit
6-21