Download INSTRUCTION MANUAL

Transcript
1.1.3.2 To change the power-line fuse
Warning! Before replacing the power-line fuse, make sure the multimeter
is disconnected from the AC power. You must be qualified personnel to perform
this action.
Warning! For continued protection against fire or instrument damage,
only replace fuse with the same type and rating. If the
instrument repeatedly blows fuses, locate and correct the cause
of the trouble before replacing the fuse. (Fuse to replace:
250VT250mA)
Verify that the power-line fuse is good. Replace the fuse if it is damaged. Use only the
same type and same rating fuse noted on the rear panel.
Please follow the steps below
to change the fuse.
【Step 1】
Verify that the meter is disconnected as shown in Figure 2-6.
Figure 2-6
【Step 2】
Open the voltage setting selector cap as shown in Figure 2-7. (You might need a
screwdriver to do so.)
Figure 2-7
6