Download User Manual - Acutec Systems

Troubleshooting and Maintenance
Series 04 Ku-Band TVRO Antenna
Install belt around CL Motor Sprocket.
Tension belt by pulling the motor bracket
down towards the antenna base and tighten
the four screws with Loctite 222.
Rotate CL beam from CCW stop to CW stop
(Left to right as viewed from behind
reflector) and verify CL belt does not rub
against AZ Post and runs inline with both
sprockets. Incorrect belt travel is most
frequently caused by incorrect sprocket
placement on elevation motor shaft.
7.4.11. Replacing CL Drive Belt
Tools Required:
•
9/64” Allen Head Wrench
•
5/32” Allen Head Wrench
•
Snips / Flush Cutters
•
2 mm Flat Blade Screwdriver
•
Loctite 222 or equiv.
NOTE: Unless otherwise indicated, all nuts and bolts should be assembled
with Loctite 222 or its equivalent.
7-34