Download User Manual - Acutec Systems

Troubleshooting and Maintenance
Series 04 Ku-Band TVRO Antenna
Remove the four 10/32 x 3/8” screws
attaching El Pan cover to El Pan bottom.
Remove the two 10/32 x ½” screws
attaching P-clamps to El Pan Cover (and El
Pan bottom).
Using 2mm flat blade screwdriver loosen the
retaining screws from the D-sub connector
and remove the level cage cable.
Carefully pull El Pan Cover away to expose
Level Cage Motor Wiring Harness and
disconnect IDC connector from Motor
Termination PCB.
Using a 2mm Flat blade Screwdriver, loosen
the 4-40 retaining screws on D-Sub
connectors and remove Polang Relay
Harnesses.
7-38