Download GasAlertMicro5 Quick Reference Guide, English

Transcript
GasAlertMicro 5/PID/IR
Quick Reference Guide
Problem
The startup self-test fails.
Possible Cause
General fault
Solution
Ensure that the sensors and battery pack are installed correctly and
then reactivate the detector.
If the fault persists, record the error message and contact
BW Technologies by Honeywell.
Detector Operation Troubleshooting
Detector does not display normal Sensor not stabilized
ambient gas readings after
startup self-test.
Detector requires calibration
Detector does not respond to
pushbuttons.
34
Used sensor: wait 60 seconds
New sensor: wait 5 minutes
Calibrate the sensors. Refer to Calibration on page 13.
Target gas is present
Detector is operating properly. Use caution in suspect areas.
Batteries are depleted
Refer to cautions in Replacing Battery Cells and Packs on page 20,
Replacing Alkaline Batteries on page 21, and Replacing Lithium
Battery Packs on page 22.
Detector is performing operations
that do not require user input
Pushbutton function restores automatically when the operation ends.