Download GasAlertMicro5 Quick Reference Guide, English
Transcript
GasAlertMicro 5/PID/IR Quick Reference Guide Problem The startup self-test fails. Possible Cause General fault Solution Ensure that the sensors and battery pack are installed correctly and then reactivate the detector. If the fault persists, record the error message and contact BW Technologies by Honeywell. Detector Operation Troubleshooting Detector does not display normal Sensor not stabilized ambient gas readings after startup self-test. Detector requires calibration Detector does not respond to pushbuttons. 34 Used sensor: wait 60 seconds New sensor: wait 5 minutes Calibrate the sensors. Refer to Calibration on page 13. Target gas is present Detector is operating properly. Use caution in suspect areas. Batteries are depleted Refer to cautions in Replacing Battery Cells and Packs on page 20, Replacing Alkaline Batteries on page 21, and Replacing Lithium Battery Packs on page 22. Detector is performing operations that do not require user input Pushbutton function restores automatically when the operation ends.