Download Operator`s Manual

Transcript
Operation
PH024490-2-17-11
The Log/Status Dialog Box (cont'd)
After making sure the DataLogger® is turned on (by pressing
and releasing the multifunction switch), tap OK to connect.
PH04492-2-17-11
Wireless
Wireless: Once connected, the dialog box starts displaying
pressure reading and the DataLogger® name and firmware
version number, and the Connect button changes to Disconnect:
Wired: Once connected, the dialog box starts displaying
pressure reading and the DataLogger® name and firmware
version number. When COM1 is selected the button is always
inactive and reads “COM1”.
Pressure reading is updated constantly as long as the DataLogger® is
connected. If there is an error due to hardware failure or out-of-range
readings, the pressure field displays ERR.
If the D-size batteries in the DataLogger® are low, the [BAT!] indicator
is displayed next to the pressure unit (psi in this example). It is best to
change batteries at your earliest convenience.
Wireless: To disconnect from the DataLogger®, tap Disconnect.
You may turn off the Pocket PC to conserve power. The DataLogger® will
automatically turn off after 2 minutes of inactivity.
TX03046-2-17-11
5-3
Wired
PH04022-1-21-10
Temperature reading is only updated when the DataLogger®
switch is held down. Otherwise, it displays - - -. If there is
an error due to hardware failure or out-of-range readings, the
temperature field displays ERR.