Download Installation / User Manual

Installer Menu
Adjusting the Gate Speed
The gate speed designates how quickly the gate opens and closes. The available range from 1 to 10 varies the
speed of the motor and the gate speed increases as you go up the number scale. The adjustable speed range is
approximately 15 seconds to 10 seconds.
NOTE
Two displays, one for OPEN SPEED the other for CLOSE SPEED, exist in the Smart DC
Controller. The steps involved in changing the open speed are shown below. The steps to set the
close speed are the same, you just need to access at the CLOSE SPEED display. The factory
defaults for both are set to a level 5, a mid-range setting.
To adjust the gate speed (1 to 10), take the following steps:
1. At a gate status display, press the MENU button
twice. This accesses the User Menu and the
CLOSE TIMER display appears.
2. Simultaneously, press the OPEN and RESET
buttons to enter the Installer Menu.
OPEN
Release the buttons and the USAGE CLASS
display appears. It is the first item in the Installer
PREV
Menu.
3. Press NEXT until the OPEN SPEED (or
CLOSE SPEED) display appears. The factory
default setting is 5.
A speed setting of 1 slows the gate travel speed to
open or close in approximately 15 seconds.
A speed setting of 10 increases gate travel and
OPEN
opens or closes in approximately 10 seconds.
4. Use the SELECT and NEXT buttons to
PREV
navigate and change the speed setting on the
display.
5. To exit the Installer Menu, press the MENU
button. The gate status appears in the display
indicating you have returned to Run Mode.
1. S.T.A.R.T. at a gate
status display.
HYSECURITY
GATE CLOSED
CLOSE
STOP
NEXT
SELECT
MENU
RESET
2. Access the User
Menu by pressing the
MENU button twice.
CT 0 (OFF)
CLOSE TIMER
CLOSE
STOP
NEXT
SELECT
MENU
RESET
3. Access the Installer
Menu, by
simultaneously,
pressing the OPEN
and RESET buttons.
UC 2
USAGE CLASS
OPEN
CLOSE
STOP
PREV
NEXT
SELECT
MENU
RESET
OS 5
OPEN SPEED
Revision E
OPEN
CLOSE
STOP
PREV
NEXT
SELECT
Display and Menu Options
MENU
RESET
4. Use NEXT to
navigate to the menu
display. Change the
setting using the
SELECT and NEXT
buttons.
3-17