Download Infra Red Remote Control
Transcript
PreAmp Control – direct commands Models Function Set Volume 0x010A Notes: Type Parameter D 2 Pronto HEX code 0000 0084 0000 000A 0010 0050 0010 0010 0020 0010 0010 0010 0020 0020 0020 0020 0010 0010 0010 00100010 0010 0010 0CF7 HV R PA3000 PA2000 P3000 PA2500 max volume =70 max volume =60 firmware >= V1.20 firmware >= V1.20 comment E Set volume to an absolute value. n.a. Note: For safety reasons the max. volume level is limited. The direct commands must be followed by a specified number of parameter bytes given in column “Parameter”. The pause between each IR command or parameter should be < 200ms. The parameter IR codes are given in table “Parameter codes for direct commands”. If a transmission error occurs or if the value is outside the defined range the command will be ignored. For these commands minimum firmware requirements must be met. Please upgrade the firmware of the T+A device if necessary. Example: To set the volume to a level of 32 transmit the IR code „Set Volume” followed by IR code for Parameter “3” followed by by IR code for Parameter “2”. The pause between each of the 3 IR codes must be shorter than 200ms.