Download Manual

Headrest
Mounting the headrest bracket
Before you can assemble of the headrest bracket can be done, you must first
remove the allen key and other necessary details that are mounted already.
Slide the rail pins of the headrest bracket (A) into the tracks of the back profile.
Once you reach the desired position, tighten the four screws (B).
Mounting the headrest
Slide the square pipe of the headrest into the headrest bracket (C) and tighten
the lever handle (D) once you reach desired position.
Height adjustment of the headrest bracket
Loosen the screws (B) and then move the headrest bracket to desired position.
Then tighten the screws (B).
Adjustment of the headrest
When adjusting the 3-joint headrest, loosen the screw (E) in the joint you
wish to adjust. Once you reach the desired position, tighten the screw (E) again.
To adjust the height of the headrest, loosen the lever handle (D) and move the
headrest to desired position. Then tighten lever handle (D).
Mounting the forehead strap bracket
Before mounting the forehead strap bracket, the head support plate (H) needs to
be removed. To remove the head support plate, loosen the two screws (I).
Fit the forehead strap bracket into the holes (F) with the supplied mounting
hardware. See separate instructions for assembly of the forehead strap bracket.
© Anatomic SITT AB
User manual - Zitzi Sharky Pro
7 (60)