Download USER`S GUIDE

Chapter 3 _______________________________________________________________ Installation
Figure 54
0311-006
Installing PWD11A (Arrow Pointing to Rain
Detector Plate)
1.
Remove the protective lens caps and take PWD11A from the
transit case.
2.
Hold the sensor in a way that the hand screw is facing down.
3.
With the hand screw facing the notch, push the sensor in place and
tighten the hand screw.
4.
Connect the DC power/signal cable to the connector PWD11A on
the Mains Power Supply QMP202 (see Figure 53 on page 64).
5.
Attach the cable to the leg of the tripod with the Velcro belt.
Setting up CT25KAM
CAUTION
1.
Open the transit case QTR104. Lift the ceilometer using the handle
of the unit and place it horizontally on the transit case as shown in
Figure 55 on page 66.
VAISALA _______________________________________________________________________ 65