Download RN1723 Data Sheet - Mouser Electronics

RN1723
4.3.3
The R&TTE Compliance Association provides
guidance on modular devices in document Technical
Guidance Note 01 available at:
http://www.rtteca.com/html/download_area.htm
Note:
A document that can be used as a starting point in
understanding the use of Short Range Devices (SRD)
in Europe is the European Radio Communications
Committee (ERC) Recommendation 70-03 E, which
can be downloaded from the European Radio Communications Office (ERO) at: http://www.ero.dk/.
To maintain conformance to the testing
listed in Table 4-1, the module shall be
installed in accordance with the
installation instructions in this data sheet
and shall not be modified.
Additional helpful web sites are:
• Radio and Telecommunications Terminal
Equipment (R&TTE):
http://ec.europa.eu/enterprise/rtte/index_en.htm
• European Conference of Postal and
Telecommunications Administrations (CEPT):
http://www.cept.org
• European Telecommunications Standards
Institute (ETSI):
http://www.etsi.org
• European Radio Communications Office (ERO):
http://www.ero.dk
• The Radio and Telecommunications Terminal
Equipment Compliance Association (R&TTE CA):
http://www.rtteca.com/
When integrating a radio module into a
completed
product
the
integrator
becomes the manufacturer of the final
product and is therefore responsible for
demonstrating compliance of the final
product with the essential requirements of
the R&TTE Directive.
4.3.1
LABELING AND USER
INFORMATION REQUIREMENTS
The label on the final product which contains the
RN1723 module must follow CE marking
requirements. The R&TTE Compliance Association
Technical Guidance Note 01 provides guidance on
final product CE marking.
4.3.2
HELPFUL WEB SITES
EXTERNAL ANTENNA
REQUIREMENTS
From R&TTE Compliance Association document
Technical Guidance Note 01:
Provided the integrator installing an assessed radio
module with an integral or specific antenna and
installed in conformance with the radio module manufacturer’s installation instructions requires no further
evaluation under Article 3.2 of the R&TTE Directive and
does not require further involvement of an R&TTE
Directive Notified Body for the final product, refer to
Section 2.2.4.
The European Compliance Testing listed in Table 4-1
was performed using the antenna types listed in
Table 3-1.
TABLE 4-1:
EUROPEAN COMPLIANCE TESTING
Certification
Standard
Safety
EN 60950-1:2006+A11:2009
+A1:2010+A12:2011
Health
EN 62479 (2010)
EMC
EN 301 489-1 V1.9.2 (2011-09)
Article
Laboratory
Report Number
Date
(3.1(a)) Worldwide
Testing
Services
(Taiwan) Co.,
(3.1(b))
Ltd.
W6R21403-14023-L
W6R21403-14023-62479 2014-05-09
W6R21403-14023-E-16
2014-05-08
(3.2)
W6R21403-14023-T-45
2014-05-09
U9M-1406-3898-C-V01
2014-06-17
2014-05-13
EN 301 489-17 V2.2.1
(2012-09)
Radio
EN 300 328 V1.8.1 (2012-06)
Notified Body
Opinion
DS70005224A-page 20
Eurofins
Product
Service GmbH
 2015 Microchip Technology Inc.