Download Manual - Festo
Transcript
Contents and general instructions Designated use The CP modules described in this manual are intended ex clusively for use on a CP string, an axis interface string or a CP branch line in conjunction with a CP field bus node, the Smart Positioning Controller type SPC200 or the Powerbox type CP−FB−TBOX−SUBD9. CP modules and CP cables are only to be used as follows: in accordance with designated use in its/their original state without any modifications by the user in faultless technical condition. When used together with commercially available compo nents, such as sensors and actuators, the specified limits for pressures, temperatures, electrical data, torques etc. must be observed. National and local safety regulations must also be observed. All CP modules comply with protection class III. Warning S Use only PELV circuits as per IEC/DIN EN 60204−1 (Pro tective Extra−Low Voltage, PELV) for the electrical supply. Consider also the general requirements for PELV circuits in accordance with IEC/DIN EN 60204−1. S Use power supplies which guarantee reliable electrical isolation of the operating voltage as per IEC/DIN EN 60204−1. Festo P.BE−CPEA−EN en 0802e V