Download Manual - Classic

 5. Using hand or a rubber hammer, taps the case to line up the screw holes on the ridge between the foot platform and the red leg pad. Screw in all six screws using the large Phillips screwdriver. Take care to turn the screws in as straight as possible. If you feel too much resistance, back the screw out, realign it and tighten again. 6. Make sure all wires are inside so that they won’t be pinched when you close the case. Screw in all fourteen screws (seven on each side) around the circumference of the case on both sides, starting with the handle. For optimal performance, keep tire pressure at 35 psi. 19