Download INCON-ME3 CNC Controller Guide

Transcript
INCON-ME3 CNC Controller Guide of Milling
3.3 Run Program〔F2→R〕
Description
R:Program execution
U:Execute program from the cursor pointed line
I :Simulate program execution
S:Stop running program
H:Pause running program
T:Toggle switch,run Single Step or continuously
K:Toggle switch,switch machine lock or unlock
A:Toggle switch, spindle axis lock/dislock motion
D:Toggle switch,switch Dry run or not
C:Toggle switch,switch Block skip or not
O:Toggle switch,switch M01 running or not
M:Manual Direct Input
Figure 3-58 The Run submenu
N:Direct run .DNC program from hard disk
3:Ignore M30 in direct running under DNC mode
G:Switch to graphic mode or not
〝Toggle switch〞is the same as state switch, each being selected will change to one mode or
the other mode, such as Off→On and On→Off; Disable→Enable and Enable→Disable.
3.3.1
Menu Item: Run→Run program
Select this menu item to execute a program according to the run state defined in
〝Parameter→Default Status→Set Run Mode〞.
Run program starts from the current cursor position. Commands before the current cursor
position, such as Status Change G-code and Motion G-code are all ignored because of no
executing program from the beginning.
82