Download INCON-ME3 CNC Controller Guide

INCON-ME3 CNC Controller Guide of Milling
axes simultaneously or signal axis. The F_ value is specified by the feed speed which is
adjusted by the rate of feed rate override operated by rotary switch on GMPU.
The unit specified G94〔mm∕min〕of F_ is different from G95〔mm∕rev〕. F_ is a
sustaining command, so it doesn't need to be specified again when the feed speed is the same
as one in the current block.
For example, under G95 mode, the feed distance of F0.1 S3000 is
0.1〔mm∕rev〕 × 3000〔rev∕min〕= 300 〔mm∕min〕
Figure4-5 G01 linear interpolation with two axes
Figure 4-6 G01 linear interpolation with three axes
Note: As for linear interpolation with two axes, G01 is not related to G17/G18/G19 plan
selection; when execute chamfering or corner rounding, G01 is related to G17/G18/G19
plan selection.
4.2.2.2
Chamfering or Corner Rounding
Format：
G01 X_Y_L_;
G01 X_Y_R_;
Chamfering or corner rounding just executes on a special plane, and its current command and
next command both must be G01.
Chamfering will add a chamfering command to the corner at the distance L_ from the corner
130