Download INCON-ME3 CNC Controller Guide
Transcript
INCON-ME3 CNC Controller Guide of Milling 3.3 Run Program〔F2→R〕 Description R:Program execution U:Execute program from the cursor pointed line I :Simulate program execution S:Stop running program H:Pause running program T:Toggle switch,run Single Step or continuously K:Toggle switch,switch machine lock or unlock A:Toggle switch, spindle axis lock/dislock motion D:Toggle switch,switch Dry run or not C:Toggle switch,switch Block skip or not O:Toggle switch,switch M01 running or not M:Manual Direct Input Figure 3-58 The Run submenu N:Direct run .DNC program from hard disk 3:Ignore M30 in direct running under DNC mode G:Switch to graphic mode or not 〝Toggle switch〞is the same as state switch, each being selected will change to one mode or the other mode, such as Off→On and On→Off; Disable→Enable and Enable→Disable. 3.3.1 Menu Item: Run→Run program Select this menu item to execute a program according to the run state defined in 〝Parameter→Default Status→Set Run Mode〞. Run program starts from the current cursor position. Commands before the current cursor position, such as Status Change G-code and Motion G-code are all ignored because of no executing program from the beginning. 82