Download Syn`X User Manual - XILS-lab

part, while the output decreases to a level specified by the Sustain setting, during a time
specified by the Decay setting. It stays on this “sustain” level as long as the EG is gated (i.e.
as long as the note is held). Then when the note in off, it goes into the “release” stage, while
the output continuously decreases to zero, depending on the Release setting.
DELAY: set the time before the envelope enters the attack
step.
MIDI Sync LED: When ON, the delay time is set according to
the Tempo of the application host.
Attack: set the time over which the output increases.
Decay: set the time the output decreases to the sustain level.
Sustain: set the sustain level, maintains while the EG is gated
(the note is held)
Release: set the time the output decrease to zero after the
note is released.
Clicking on the tab allows the editing of envelope 3 or 4.
8.1.5 Noise Generator
WHITE/PINK: Allows you to select either white or pink noise to be added to the oscillators in
the mix going to the filter. White noise contains all the audible frequencies at equal level, while
pink noise contains all the audible frequencies at equal energy, meaning the more the
frequency increases, the more the level decreases.
VOLUME: This controls the level of the noise adding to the oscillators.
8.1.6 LFO1/2
The Syn'X proposes two Low Frequency Oscillators, which can be used as modulation sources.
To switch between the two LFOs, just click on the label LFO1 or LFO2.
FREQ: Controls the speed of the modulation effect.
DEPTH A, DEPTH B: Regulates the different amounts of the modulation, Depth A, for the
oscillator Modulations, Depth B for the Filter and Output Amplifier modulation.
Waveforms Buttons: The various switches select the different available LFO waveform(s).
Sine, Triangle, Saw, Ramp, Square, Random (S&H).
Please note that you can select different waveform simultaneously, and can therefore build
unusual and very complex LFO waveforms when combining several waveforms.
Tip: This is especially handy if you wish to add some subtle movements and modulations to an
instrument. Adding several waveforms to an LFO will avoid the repetitive feel of the LFO.
DELAY: set the delay time between a note ON and the beginning of the fade in.
FADE: set the time for the output to rise from zero to the maximum level.
Reset LED (close to DELAY): Reset the LFO waveform when the Note is ON.
- 25 -