Download Instruction Manual

USER MANUAL
ENGLISH
Getting Started
Determine how you want to set up your BAR1 and Wireless Subwoofer Audio System.
The following figures show 2 typical installation styles. One is the Table Top style and the other is the Wall Mount style.
Table Top Style
Wall Mount Style
You can set the BAR1 on the cabinet that is properly
designed to place the BAR1 and the TV. Please install
the supplied stands by following the instruction that is
shown on the bottom of this page. You can place the
Subwoofer on the floor.
You can mount the BAR1 on a wall by using the
supplied hardware kit. The input jacks and power cord
are designed to allow a flush mount. Please follow the
instructions that are shown on page 8 of this Owners
Guide. You can place the Subwoofer on the floor.
Think About Location
The wireless range of your BAR1 is up to 100 feet, but it may vary depending on your operating environment. Select an area where
sunlight will not fall directly on the products. Also, be sure that the location selected allows a free flow of air to and from the products.
In order to prevent an internal temperature increase, maintain the following space requirements.
BAR1
Subwoofer
Top / Bottom / Back: No clearance required - can be flush mounted.
Left / Right: At least 6” (150 mm) clearance required.
Front: Open between the BAR1 and the listeners.
Top / Back / Left / Right: At least 2” (50 mm) clearance required.
Front: Open between the BAR1 and the listeners.
Installing the stands
In order to place the BAR1 on the cabinet or the shelf, you need to install the supplied 2 (two) stands by using the
following installation guide. Please make sure that the cabinet or the shelf is strong enough and well secured.
Step 1
Step 2
Step 3
Step 4
Insert the top tab of
the stand into the hole
provided for the stand in
the back of the BAR1
Make sure that the top
tab is fully inserted into
the hole.
Swing down the stand all the way until
the stand hits the Soundbar so that the
base of the stand will be underneath of
the bottom of the BAR1. Then push up
the stand to fit the BAR1.
Make sure that the both stands
are installed as shown in the
above picture.
rothaudio.co.uk | 7
Roth SoundBar Manual EH.indd 7
7/3/11 11:20:06