Download Instructions Installation Commissioning

F
F
Attach the second spacer (8)
using the screw 2.
Tighten, without locking.
F
Attach the self-adhesive strip
vertically along the edge.
F
At the bottom, cut off any
excess material.
Preparation the existing extensible unit (Version after 03/2008)
F
F
F
Loosen, alternately, the
two fixing bolts of the insulated
end cap compression plate.
Wear gloves to remove the
plugs.
Apply an alternative side to side
force on each plug, so that air
can progressively enter into the
plug-crossmember interface
whilst pulling towards the rear.
22
Light pressure is
applied by the insulated
blanking plugs to this plate.
F
Clean the inside of the three
bushings with a cleaning cloth
(2).
F
F
Remove the plate.
Put on the glove (3) to cover the
insides of the bushings with a
thin coating of grease (4).