Download Vibrating Sample Magnetometer - Materials Research Facilities

Transcript
Section 5.5
VSM Electronics
5.4
Chapter 5
VSM Hardware
Sample-Mounting Station
The sample-mounting station (4096-110) is used to precisely locate and measure (within 0.5 mm)
the sample offset, which is the distance between the sample and the bottom of the sample holder
(see Figure 5-8).
Figure 5-8. Sample-mounting station (4096-110)
The VSM measurement algorithm requires an accurate measurement of this distance so that it can
perform touchdown operations (See Chapters 1 and 4 for more details about touchdown
operations).
5.5
VSM Electronics
5.5.1
Preamp Cable Assembly
Figure 5-9 shows the preamp cable assembly (3096-300), which is the electrical connection
between the coilset puck and the “PREAMP” port (JB-3) on the Model CM-B detection module.
Integrated into the cable are dual 40-gain preamplifiers for up to two independent detection coils.
The preamp end of the cable is plugged into the gray connector at the PPMS probe head.
Figure 5-9. Preamp cable assembly (3096-300)
5-8
VSM Option User’s Manual, 1096-100, Rev. B0
February 2011
Quantum Design