Download User Manual

Transcript
2 Graphical user interface
2.5 Display zone
sheet reference. All other images in the sheet are compared to this
sheet reference when using the menu commands in View > Sheet.
To hide the image names, choose View > Global > Show Gel Names.
The image name is replaced by three dots.
Move the mouse over an image name to view a screentip specifying
the match hierarchy. In a Class sheet, the class and path to which it
belongs are also given. If the image is the sheet reference, then this fact
is included in the screentip.
Selection
Select an image by clicking on its name. Use the Shift or Ctrl keys to
make multiple selections. Click the pane tab to select all images in a
pane.
When images are hidden like in Stacked mode, bring an image to the
front by clicking on its tab at the bottom of the pane. Quickly sift through
images using the Page Up and Page Down keys on your keyboard or
click on the navigation triangles in the lower right corner of a pane.
Scrollbars
The scrollbars on the right and bottom edges of each image can be
used to change the zoom factor of an image by dragging one of the
ends of the scrollbar. You can also move the visible area of the gel
horizontally or vertically by clicking in the middle of the scrollbar and
dragging left/right or up/down.
Click on the gray square at the intersection of two scrollbars to reset the
image to its full image size.
If you want to view a specific area of your gel image, choose View >
Global > Scrollbars > Adjust. In the Adjust Visible Area window, set the
exact horizontal and vertical start and end coordinates for the area to
be displayed. You can do this in terms of different units: Pixel coordinate,
Percentage and Real coordinate (pI and MW). Please note that pI_MW
annotations must be defined in order to use this function.
To hide the scrollbars, choose View > Global > Scrollbars > Show. In that
case, You can still move and zoom images by using the Move and
Zoom tools in the toolbar.
2.5.4
Switch order
You can change the order in which images are displayed by dragging
the gel name onto another image. It is then inserted before this image.
Similarly, you can re-order panes by dragging their tabs to a new
position.
Swap panes or images by choosing View > Sheet > (Navigation >)
Switch or the Ctrl+F shortcut. This reverses the last re-ordering operation
applied to a pane or image.
22
Melanie User Manual Edition AC