Download CE EMC TEST REPORT - Edge-Core

Reference No: KS101108A01-ET
Report No.: KS101108A01-ET
8.4.4. TEST SETUP
3 meter
RS Chamber
EUT & Support
Units
1.5 meter
0.8m
Power Amp
Signal
Generator
PC Controller to
control S.G. & PA as
well as forward
power
z
EUT Monitoring by
using a camera
Control Room
For the actual test configuration, please refer to the related item – Photographs of
the Test Configuration.
NOTE:
TABLETOP EQUIPMENT
The EUT installed in a representative system as described in section 7 of EN 61000-4-3 was placed on a
non-conductive table 0.8 meters in height. The system under test was connected to the power and signal
wire according to relevant installation instructions.
FLOOR STANDING EQUIPMENT
The EUT installed in a representative system as described in section 7 of EN 61000-4-3 was placed on a
non-conductive wood support 0.1 meters in height. The system under test was connected to the power and
signal wire according to relevant installation instructions.
Page 51
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.