Download ION Reference Guide

ION REFERENCE
09/2008
Bin Module
The Bin module counts how many times a user-defined rule is satisfied by the
module’s inputs. When an input satisfies one of the twenty-five rules, a
corresponding output increments, allowing you to count the number of times an
input met a rule.
Bin Module
Bin 1
Bin 2
Source A
Source B
Nominal A
Nominal B
Bin 25
Event
Evaluate
Enable
Reset
Inputs
Source A
The input value from Source A is tested against all of the arguments in the Rule
setup registers. Linking this input is optional.
Source B
The input value from Source B is tested against all of the arguments in the Rule
setup registers. Linking this input is optional.
Nominal A
This input is used as the nominal value of Source A in the Rule setup registers if
Eval Mode A is set appropriately. Refer to the Eval Mode A setup register below.
Nominal B
This input is used as the nominal value of Source B in the Rule setup registers if
Eval Mode B is set appropriately. Refer to the Eval Mode B setup register below.
Schneider Electric
2195 Keating Cross Road
Saanichton, BC
Canada V8M 2A5
Tel: 1-250-652-7100
For technical support:
[email protected]
(00) + 1 250 544 3010
Contact your local Schneider Electric sales representative
for assistance or go to
www.powerlogic.com
ION, PowerLogic and Schneider Electric are trademarks or registered trademarks of
Schneider Electric in France, the USA and other countries. Other trademarks used are the
property of their respective owners.
Electrical equipment should be installed, operated, serviced, and maintained only by qualified
personnel. No responsibility is assumed by Schneider Electric for any consequences arising
out of the use of this material.
© 2008 Schneider Electric. All rights reserved.