Download fulltext - DiVA Portal

Transcript
36
CHAPTER 6. IMPLEMENT APPLICATION ON VNC
consider it.
2: The second mode is normal mode, which CPU never stop running. It cost too
much power consumption under this mode.
3: The last mode is power down mode, when PN532 works in this model, oscillator
is stopped when it is idle.
PN532 works under low power mode likes a wheel we can see in figure 6.2. It has
four state: Idle, Initialize, Listen and Data Communication. When it doesn’t work
it always in IDLE power down mode, once start one phase works after another, it
will not stop until user stop or remote device, after that it will go back to idle power
down phase.
IDLE(power down)
Data
Communication
initialize
Listen
Figure 6.3. PN532 Low Power working state
Wake Up
Low power mode can save power consumption, increase sensor nodes life time. As
the cost, it takes 50 ms to wake up the PN532 from sleeping. In order to exit from
Power Down mode, the host controller need to send a command to the PN532 on
th HSU link. Besides to avoid the command will not be lost or partially received,
either we send a large preamble containing dummy data command or a 0x55 dummy
byte and wait for the waking up delay before sending the command frame. In this
thesis project, we use 0x55 0x55 0x00 0x00 0x00 0x00 0x00 0xFF 0x03 0xFD 0xD4
0x14 0x01 0x17 0x00 command to wake up the PN532. Here SAMConfiguration
command D4 14 which is used to select the data flow path by configuring the internal
serial data switch. D4 14 01 means the SAM is not used and it works under normal
mode. And IRQ byte is not present, it indicates PN532 ignoring the IRQ pin.