Download Operating Manual - TV

Chapter 2
2
Initial Setup Procedures
2.1 Control Unit Option Module Setup
1.
Open the front panel door and determine if any of the following options are installed:
■
Convectron Gauge
■
Convectron/Capacitance Manometer Gauge
■
Process Control
■
RS-485 Computer Interface
■
RS-232 Computer Interface
■
IEEE 488 Computer Interface
PROCESS CONTROL
Off SP On
▲
▲
RS-232
1
CONVECTRON
Data Port
SET
▲
2
ATM
Set
3
▲
4
VAC
IG-2 AUTO
OFF
3
ATM
6
▲
Off SP On
VAC
IG1
IG2
O
O
Degas
Power
O
O
IG1 L F1
N2 TORR
SET
5
▲
ELECTROMETER
IG-1 AUTO
OFF
▲
Cancel
▼
Select
Figure 2-1 Control Unit Front Panel (with Door Open) Showing Location of
Computer Interface and Process Control Modules
2.
If none of the above options are present skip to Section 2.2 Power Supply Setup on page 2-15.
3.
If one or more of the above options is present you may find it necessary to re-configure certain
switches within the Control Unit. See Section 2.1.1 on page 2-2 and the following sections for
further details.
Review Sections 2.1.2, 2.1.3, 2.1.4, 2.1.5, and 2.1.6 for the factory default settings for the
switches or settings on these options to determine if any need changing. Now is a convenient
time to make any required switch changes before mounting the Control Unit in its desired
location.
2-1
Series 370 Stabil-Ion Instruction Manual - 370119 - Rev. 05