Download PrPMC8005E Processor PMC Module Installation and Use

6 Modifying the Environment
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Y
NVRAM (PReP partition) header space will be initialized automatically
during board initialization, but only if the PReP partition fails a sanity
check. (Default)
N
NVRAM header space will not be initialized automatically during board
initialization.
Network PReP-Boot Mode Enable [Y/N] = N?
Y
Enable PReP-style network booting (same boot image from a network
interface as from a mass storage device).
N
Do not enable PReP-style network booting. (Default)
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Y
Local SCSI bus is reset on debugger setup.
N
Local SCSI bus is not reset on debugger setup. (Default)
Primary SCSI Bus Negotiations Type [A/S/N] = A?
A
Asynchronous SCSI bus negotiation. (Default)
S
Synchronous SCSI bus negotiation.
N
None.
Primary SCSI Data Bus Width [W/N] = N?
W
Wide SCSI (16-bit bus).
N
Narrow SCSI (8-bit bus). (Default)
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?
Y
Give boot priority to devices defined in the fw-boot-path global
environment variable (GEV).
N
Do not give boot priority to devices listed in the fw-boot-path GEV.
(Default)
When enabled, the GEV (Global Environment Variable) boot takes priority over
all other boots, including Autoboot and Network Boot.
NVRAM Bootlist (GEV.fw-boot-path) Boot at power-up only [Y/N] = N?
Y
Give boot priority to devices defined in the fw-boot-path GEV at
power-up reset only.
N
Give power-up boot priority to devices listed in the fw-boot-path GEV
at any reset. (Default)
PrPMC8005E Processor PMC Module Installation and Use (6806800A42B)
51