Download Emulex® Drivers for Linux User Manual

4. Troubleshooting
FC Log Messages
Table 4-2 LPFC Error Log Messages and their Descriptions (Continued)
0378: No support for fcpi mode.
Could not configure the port to run in FCP initiator mode.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action: None required.
0379: Feature Mismatch Data: <req ftr word2 hex> <req_ftr word3 hex>
<cfg_enable_npiv> <max vpi hex>
The features passed in to the driver as module parameters do not match what the firmware can do.
Setting to default values.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action: None required.
0381: Error %d during queue setup.
Could not set up all the queues that driver requires to exchange IOs with the HBA.
Data:
None
Severity: Error
Log:
LOG_MBOX, LOG_SLI
Action: Reload the driver.
0382: READ_SPARAM command failed status <issue status>, mbxStatus <mailbox
status>
The READ_SPARAM mailbox command has failed during initialization. The HBA has been set to error
state.
Data:
None
Severity: Error
Log:
LOG_MBOX, LOG_SLI:
Action: Take a dump with hbacmd and then try reloading the driver.
0383: Error <rc> during scsi sgl post operation
The SGL entries could not be registered with the adapter.
Data:
None
Severity: Warning
Log:
LOG_MBOX, LOG_SLI
Action: Reset the adapter using hbacmd.
0384: There is pending active mailbox cmd
The mailbox commands have overlapped. This command should have been added to the mailbox
queue.
Data:
None
Severity: Error
Log:
LOG_MBOX, LOG_SLI
Action: None required.
Emulex Drivers for Linux User Manual
P007633-01A Rev. A
58