Download "user manual"

Sectioon III – Schedule of Reequirementss
3
Tecchnical Specifiicationss
Comparrative Data Table
Bidder/s muust complete the right collumn of the below
b
table and
a the comppliance confi
firmation stattement as
included in section III, schedule
s
of Requirement
R
ts; Technical Specificatioons.
Compliancce Table
Bidder/s is rrequired to provide
p
a manndatory ITB compliance statement inndicating anyy deviations ffrom items
in the ITB/S
Specificationn. Indicate ann exception to
o the requireement by the word “Exceeption – see vendor’s
v
technical sppecification below”
b
follow
wing the appplicable Articcle number. Should
S
the proposed gooods not
entirely com
mply with thee requiremennts specified,, but ultimateely achieve thhe intent, thee Proponent shall
explain fullyy the extent, or lack thereeof, of comp
pliance for thhe applicable exception prroposed. Insttances
where theree is no indicaation of excepption taken shall
s
be considered comp
pliant.
LO
OT NO. ONE: MOTOR
RCYCLES
S TRACKING DEVIC
CES
Item
1.2
Descripttion
Motorcycles Tracking Devices
D
(Qu
uantity 1000)
Daata Commu
unications:
 SMS/GPR
RS/RS232
 Quad-bandd EGSM 8550/900/18000/1900
 GPRS classs 10
GP
PS:
 GPS basedd on NMEA
A 0183 outpuut format
 Accuracy < 2.5 meterrs
 Hot start < 1 second
 External Antenna
A
inclluded
Inp
puts/Outpu
uts and sensors:
 2 Analog Inputs
I
that can
c operate as Digital inputs
i
(Actiive High /
Active Low
w)
 2 Outputs open collecctor driven 150mA
1
at 12V DC
 CAN bus interface
i
Power:
 Operating Voltage 12V
V DC
 Backup baattery - Li-ioon 1000 mA
Ah
Op
perating en
nvironment:
 IP66 envirronment prootection leveel
 Operating temperaturre: 0°C to 500°C
Doocumentatioon in Engliish:
 User manuual
 Detailed documentati
d
on of the appplication innterface andd data
transmissio
on protocolls
 Installationn instructionns
Ad
dditional:
 ON Board
d status led
 Built in G sensor
 Jamming detection
d
 Panic Buttton
 RFID proxximity card reader supp
port for drivver identificcation and
authorizatiion
Insstallation:
 Device insstalled in thee Motorcyccle
ITB No. UNOP
PS/JMPC/0008
80256/ITB/20133/003
Pleasse fill-in
(Yees/No)
(Yees/No)
(Yees/No)
(Yees/No)
(Yees/No)
(Yees/No)
(Yees/No)
(Yees/No)
Page 37 of 50
0