Download - Datacolor Industrial

6.3
Setting the set point values
General notes:
The controller MB1 is equipped to control two
parameters (temperature and humidity).
The set-points are pre-set in factory to the
standard values: 21°C and 65% RH
All set-point values can be changed as
described here.
For a negative set-point entry, enter the
numerical value first and only then the
negative sign (-).
Setting ranges of
CONDITIONER™ with lighting unit:
Temperature: 10°C (without humidity) up to 50°C.
Humidity: 10 % RH to 70 % RH
Light intensity: 0 % to 100 % (Light intensity
in LUX see chap. 11)
For possible combinations of temperature and
humidity values without condensation see
operating range, chap. 10.1
Setting ranges of
CONDITIONER™ without lighting unit:
Temperature: +10°C up to 90°C.
Humidity: 10 % RH to 90 % RH
For possible combinations of temperature and
humidity values without condensation see
operating range, chap. 10.2
08:43:55 20.03.05
TEMP
21.0
HUMID
65.0
20.8 °C
64.3 %rH
08:44:05 20.03.05
Enter setpoint
TEMP
HUMID
INTEN
+ 21.0 °C
+ 65.0 % rh
+ 100 %
Select the parameter to change
with the arrow buttons
08:44:15 10.03.05
If the safety controller is set to set-point type
“Limit”, you need to adjust it every time after
changing the temperature set-point (see chap.
8.1). Set the safety controller about 2 to 5°C
higher than the desired temperature set-point.
Only then correct function of the cabinet is
guaranteed.
• CONDITIONER™ with lighting unit:
If the temperature value of 55°C is uncritical
for the charging material, it is
recommended to keep the safety controller
set to the standard factory setting of 55°C.
Enter setpoint
TEM
HUMIDTEMP
INTEN
EXIT
+
65.0 % rh
+0021.0 ° C
Arrow buttons to
enter the value
Arrow button to move
the dicimal point
• CONDITIONER™ without lighting unit:
If the temperature value of 90°C is uncritical
for the charging material, it is
recommended to keep the safety controller
set to the standard factory setting of 90°C.
If the safety controller is set to set-point type
“Offset”, it is recommended to set the set-point
of the safety controller to 2°C to 5°C.
Datacolor Conditioner Operation Manual / DCCOPMN_MB1 / Rev 4.0 / 11th December 06
page 31/52