Download Digital Super Hybrid System Programming Guide

4.4
TIE Line Programming
[438] TIE-to-Outside Transfer
Description
Enables or disables transferring TIE calls to an outside line on an outside line group basis. This
restriction applies to the following: 1) An outside call through another PBX 2) Call Forwarding
to an outside line 3) Call Transfer to an outside line.
Selection
• Outside line group (TRG) number: 1 through 8, ( =all outside line groups)
• Enable / Disable
Default
All outside line groups – Disable
Programming
1. Enter 438.
Display: TIE-CO Transfer
2. Press NEXT.
Display: TRK GRP NO?
3. Enter an outside line group numbe .
To enter outside line group number 1, you can also press NEXT.
Display example: TRG1:Disable
4. Keep pressing SELECT until the desired selection is displayed.
5. Press STORE.
6. To programme another outside line group, press NEXT or PREV, or SELECT and the
desired outside line group numbe .
7. Repeat steps 4 through 6.
8. Press END.
Conditions
To assign all outside line groups to the same selection, press the key in step 3. In this case,
the display shows the contents programmed for outside line group number 1.
Features Guide References
E&M (TIE) Line Service
E & M Programming
321