Download EOTec 2104 User Manual

Standards and Safety
The EOTec 2104 Ethernet Ring Switch from Weed Instrument has been designed to meet the
following standards.
Electrical safety – CSA C22.2/14; IEC61010-1
EMI emissions – FCC part 15, ICES 003, EN55022
EMC immunity – IEC61326-1
FM/cFM Class I, Division 2, Groups A, B, C, and D, T4
(-40°C To +85°C)
WARNING – EXPOSURE TO SOME CHEMICALS MAY DEGRADE THE
SEALING PROPERTIES OF MATERIALS USED IN THE FOLLOWING
DEVICES:
RELAYS K1, K2 & K3 – LCP resin housing with epoxy resin seal
If the above devices are exposed to degrading chemicals, it is recommended
that periodic inspection be performed and replacement of the unit occur if
degradation is found.
Install the Weed Ring Switch in accordance with local and national electrical
codes.
Lightning Danger: Do not work on equipment during periods of lightning activity.
Do not connect a telephone line into the Ethernet RJ45 connectors.
Refer to the Technical Specifications section, at the end of this manual, for complete
specifications on agency approvals.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate the receiving antenna; Increase the
separation between the equipment and receiver; Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected; Consult the dealer or an
experienced radio/TV technician for help.
iii