Download bfspufdi

WINTERIZING FAN
In most climates, it is probable that the ventilation system will never need to operate at a total capacity during the colder winter months. Consequently, it is advisable to "winterize" those fans which
will not be used in cold weather to avoid unnecessary heat loss and condensation.
To winterize, turn fan control "off" and install an insulated closure panel over the fan intake. If you
don't have an insulated closure panel, a piece of rigid insulation material can be used. Remember
the insulation panel must be removed before warmer weather returns.
NOTE: At least one single speed fan should be left uncovered and with power available to provide
air movement in the event of variable speed control difficulties.
TROUBLE SHOOTING
!
WARNING
High Voltage,
disconnect power
before servicing.
!
WARNING
Moving parts,
disconnect power
before servicing.
WARNING
Moving parts,
disconnect power
before servicing.
POSSIBLE CAUSES
SYMPTOM
Fan Not Operating
!
CORRECTIVE ACTION
1. Fan control set above room
temperature
2. Blown fuse or open circuit breaker
3. Propeller blade contacting fan
housing
4. Fan control defective
5. Motor defective
1. Set to a lower temperature
Fan OperatingInsufficient Airflow
1.
2.
3.
4.
1.
2.
3.
4.
Excessive Fan
Noise
1. Propeller blade contacting fan panel
2. Motor bearing defective
1. Realign propeller in fan housing
2. Repair or replace motor
Excessive Fan
Vibration
1. Motor loose in mount
2. Propeller damaged
3. Motor shaft bent
1. Tighten fasteners
2. Replace propeller
3. Repair or replace motor
Fan Never Turns Off
1. Override thermostat set incorrectly
2. Control set for continuous operation
1. Set to the correct temperature
2. Set speed control correctly
Shutter jammed
Guard dirty
Incorrect Belt Tension
Worn pulleys.
Munters Corporation
4215 Legion Dr. Mason, MI 48854-1036 USA
Ph. (517) 676-7070 Fax (517) 676-7078
www.munters.us/aerotech
2. Replace fuse or reset breaker
3. Realign propeller in fan housing
4. Repair or replace control
5. Repair or replace motor
Clean shutter & fan housing
Clean guard
See Maintenance Section.
See Maintenance Section.
FORM: QM1072
Rev. 4, June 2009
Page 10 of 12