Download User Manual - AMTEC Logo

TEMES User Manual
table of contents
Page 2
1 Introduction ...................................................................................................... 5 2 Installing the software TEMESfl.cal .................................................................... 6 2.1. Software protection .................................................................................. 6 2.2. Installing a single user version ................................................................. 6 2.3. Installing a network version...................................................................... 7 2.4. Uninstalling the software TEMESfl.cal........................................................ 8 3 Software TEMESfl.cal ......................................................................................... 9 3.1 Program start ........................................................................................... 9 3.2 TEMESfl.cal input window – general information ..................................... 11 3.3 TEMESfl.cal – Results - General information ........................................... 19 3.4 Program module KTA 3211.2 (KHS) – user interface ............................ 24 3.4.1 Mask “general“ ............................................................................ 24 3.4.2 Mask “load “ ................................................................................ 26 3.4.3 Mask “flange 1“ ........................................................................... 28 3.4.4 Mask “flange 2“ ........................................................................... 31 3.4.5 Mask “raised faces“ ..................................................................... 32 3.4.6 Mask “bolts“ ................................................................................. 36 3.4.7 Mask “thread“ .............................................................................. 40 3.4.8 Mask “extension sleeve“.............................................................. 41 3.4.9 Mask “gasket geometry“ .............................................................. 42 3.4.10 Mask “gasket material“ ................................................................ 46 3.4.11 Mask “fl. 1 material“ ..................................................................... 48 3.4.12 Mask “loose flange 1 material“ .................................................... 49 3.4.13 Mask “fl. 2 material“ ..................................................................... 50 3.4.14 Mask “loose flange 2 material“ .................................................... 50 3.4.15 Mask “material of bolts“ ............................................................... 51 3.4.16 Mask “material of extension sleeve“ ............................................ 51 3.4.17 Mask “assembly“ ......................................................................... 52 3.5 Program module KTA 3211.2 (standard) – results ................................. 53 3.5.1 Mask “bolt forces“ ........................................................................ 54 3.5.2 Mask “dimensioning of bolts“ ....................................................... 55 3.5.3 Mask “fl. 1 dimensioning“ ............................................................ 56