Download User Manual

webcamXP 5 documentation
Once a category for audio drivers is selected, a list of the available drivers will be displayed. Note: If no drivers
are displayed, make sure that the correct drivers for your microphone are installed. Drivers should be available
from an installation CD shipped with the microphone or as a download from the microphone manufacturer’s
website.
Select the driver that is most applicable to your microphone hardware.
4.1.4.2 Specifying Audio Sources
Once an audio driver is selected (see section above), you must specify the type of input the audio driver will
handle. The source or type of audio input determines the strength of the audio signal and thus the volume of
the audio signal. webcamXP can take this data from the microphone line (e.g. the data directly form the
microphone), the line in volume (specified by the operating system), or a stereo mix between the two. When
stereo mix is selected, webcamXP will attempt to find a “happy medium” between the two inputs, returning a
volume that accurately portrays the data being read from the microphone device.
To select the audio input type or source, right-click in the Source Selection box. Place your cursor over the
Audio Input option. The following menu should appear:
Select the type or source you wish to use for your audio input.
4.1.5 Panning and Zooming a Camera
Panning and Zooming a camera can be accomplished from the Pan, Tilt, Zoom box of the Live View /
Source Selection / Controls tab. The Pan, Tilt, Zoom box is shown below:
First, select the camera you wish to pan, tilt, or zoom by clicking on its representation box in the Source
Selection box.
If the Enabled checkbox in the Pan, Tilt, Zoom area is not checked, place a check in it by clicking on it. This
entry will make the pan, tilt, and zoom options available to the currently-selected camera.
The magnifying glass icons to the upper right and upper left of the box control zoom functionality. The
magnifying glass with a minus (-) sign zooms out. The magnifying glass with the plus sign (+) zooms in.
The four directional arrow keys tilt and pan the camera. The up arrow tilts it up, the down arrow tilts it down,
the left arrow pans it left, and the right arrow pans it right.
The center diamond-shaped button returns the camera to its original (and default) position (i.e. it centers the
camera).
In order to center the image on a specific location (e.g. shift the camera to focus on a particular region of the
image), simply click on that location in the camera’s image output box.
4.1.6 Capturing a Still Image from a Camera
To capture a still image, use the Controls buttons from the Live View / Source Selection / Controls box:
- 21 -