Download User Manual - IDB instruments

User Manual ZFG 3.0
2.2 Plug in/ remove SD-card
To plug the SD-card into the ZFG 3.0 hold the card as shown on Picture 1. Push the card in as far as
possible until a click sounds. When the card is plugged in correctly, it sticks 3 mm out of the top.
To remove the card, push it into the device. It sounds a click and the card will be pushed out 7 mm.
Now it can be pulled out.
4
1.
2.
3.
4.
5.
6.
7.
5
6
7
1
Symbol LWD
Sensorjack at ZFG 3.0
SD-card
Symbol printer
Symbol SD-card
Printerjack at ZFG 3.0
SD-slot
2
3
Picture 1: ZFG 3.0 top side
Be careful when plugging in or removing the SD-card. Be sure to insert the card the right way round.
The SD-card has to be plugged in and removed easily from the slot.
- 8-