Download Chapter 1 - Raymarine

4. Refer to the relevant Manufacturer’s handbook for details on
configuring your IRD.
Refer to the relevant Manufacturer’s handbook for details on
configuring IRDs.
System with 2 IRDs
System with more than 2 IRDs
Antenna base plate
RF 1
To connect multiple IRDs to your antenna, you require a suitable
multiswitch connected as shown in the diagram.
RF 2
IRD2 (not supplied)
RF cable
to TV monitor (not supplied)
IRD1 (not supplied)
to TV monitor (not supplied)
ACU
MADE IN KOREA
ANT RF1
RECEIVER
+
-
+
DC 9 to 30V
FUSE
NMEA
PC INTERFACE
D11732-1
-
Power in
You can connect two IRDs to your antenna as shown in the following
diagram. In this system, one IRD can be set as a two satellite
receiver. The other IRD must be set as a one satellite receiver.
The RF cables from the antenna base plate connect to either the
LNB, ANT, or Satellite In connector on the rear of the IRD.
Installation
21