Download User Manual

Transcript
CHAPTER 6 - TROUBLESHOOTING
This chapter explains all of error contents which may occurs during system management,
cause detection, and how to take action. If error occurred in communication module,
error contents are displayed through LED of communication module.
LED
OP
LED
LED State
Not flickering
Lighting periodically
ERR
LED
TXD,
RXD
LED
Checkup
1. No applying Power
supply
2. Abnormal CPU
operation
3. LED fault
Comm. frame fault by
electric noise
Flickering conversely
to OP cycle
Fnet comm. error
Flickering same cycle
as OP
DPRAM error
Flickering with 500ms
when TXD, RXD LED
is turn off.
Abnormal communication
Flickering with 500ms
when TXD and RXD
LED are turned on.
Motor is not operated
when
RXD and TXD LED
are turned off and OP
LED is flickering with
1 sec.
Way of check up
1. Check the connection with the
inverter or power supply of inverter.
2,3. Repair or replacement.
Check the comm. cable whether
there is a noise factor.
Check the connecting of
communication cable.
Check the PLC communication state
(Enable state).
Check the connection with the
inverter or power supply of inverter.
Repair or replacement.
Check the connecting of
communication cable.
Check the PLC communication state
(Enable state).
Wrong comm. setting
during normal comm.
Check the setting of inverter station
address.
Normal state
Check the No. 51 Opt mode of EXT
Group set.