Download Tissuelyser User Manual - UTA

Operating Procedures
To retrieve disruption parameters from the memory, press the “PROG” key
repeatedly until the desired storage location (i.e., “P1” to “P9”) is displayed.
Then press the “START” key to start operation of the TissueLyser II.
5.3 Displaying the accumulated operating time
To display the total amount of time that the TissueLyser II has been operated,
follow the procedure below.
1. When the TissueLyser II is in standby mode, simultaneously press the “SET”
key and the “–” key under the “Frequency 1/s” display.
2. “bS” appears in the “Memory” display. In addition, the accumulated
operating time for the TissueLyser II is displayed in hours and minutes in the
“Frequency 1/s” and “Time min/sec” displays.
3. Press the “STOP” key to cancel the display.
5.4 Displaying the software version
To display the software version installed on the TissueLyser II, follow the
procedure below.
1. When the TissueLyser II is in standby mode, simultaneously press the “SET”
key and the “+” key under the “Frequency 1/s” display.
2. “S” appears in the “Memory” display. In addition, the software version is
displayed in the “Frequency 1/s” display.
3. Press the “STOP” key to cancel the display.
TissueLyser II User Manual 04/2010
29