Download Specification

Start Position Specification
Specifies the start position coordinate.
Specifies the vertical start position correction signal.
+, –
Specifies the vertical start position correction signal as dot.
0 - 999
Specifies the horizontal start position correction signal.
+, –
Start Point
Specifies the horizontal start position correction
after
signal as dot.
specifying
0 - 800
Start Point
before specifying
H
V
When you turn off the printer, all specified
values are invalid.
Sensor Selection
Specifies the sensor type.
Sensor Type Specification (Default: 1)
1. Reflection sensor (Eye mark)
2. Transparent sensor (Space)
3. Sensor Ignore type
You do not have to specify this command for regular label printing.
When you turn off the printer, all specified values are invalid and the registered values in the
printer are valid when the printer is restarted.
Save Settings
The <PG> command registers and saves the printer settings into the EEPROM.
The settings to be registered as follows.
<<CL408e • CL412e • CL608e • CL612e • M-8400RVe>>
In general, you should adjust the settings from the User Mode of the printer.
<< CT400DT/TT • CL410DT/TT >>
Refer to the User Manual to change the registered values such as Print Speed, Cutter
Operation, Dispenser Operation, Linerless Operation, Print Density, Sensor Type, Kanji
Code, 0 Slash, Label Specification, Initial Feed, Proportional Pitch, Label Size, Start Position
Correction Value, Label Pitch, Offset, TearOff Offset, Cutter Offset, Dispenser Offset, Space
Size between Labels and Alarm Sound Setting, use the PG command or the “Printer Setting
Tool” on CD-ROM that comes with the printer. For details on the “Printer Setting Tool”, refer
to the manual.
10