Download Manual

5.4.1. Ending an IP communication (Ethernet interface).
•
To end the communication, you need only to press the red button on the control
surface. At the other end of the communication, the call will be automatically
terminated.
5.4.2. Reception and acceptance of an IP communication (Ethernet interface).
If the Ethernet interface of the codec is suitably configured and the automatic answering mode
is OFF:
•
•
•
•
•
The unit will emit an audible notification signal. You can disable it in Menu >>
Advanced >> Settings >> Local Config >> Buzzer (change it to OFF) or configure the
length (in case of automatic answering) in Menu >> Advanced >> Communications
>> SIP Config >> Call Settings >> Auto Answer - Ringing Time.
The alphanumeric keypad backlighting will blink to warn the user (only when “Buzzer” is
OFF).
The information on the calling URI will appear in the upper part of the TFT screen.
Press the green button on the control surface to accept the call. In the upper area of
the TFT screen, the synchronization status of the connection can be displayed. If you
do not wish to accept the call, press the red button to reject it.
Once the connection has been correctly established, the LED
next to the transmission button corresponding to the used
channel (Program or Coordination) will remain green-lighted.
Activate the channel communication circuit by pressing that
button (it will light up on red).
The automatic answering mode can be activated/deactivated in Menu >> Advanced >>
Communications >> SIP Config >> Call Settings >> Auto Answer - Activate.
5.5. Establishment of a POTS communication.
•
•
•
•
•
•
•
Make sure the codec is powered up.
Check that the standard cable terminated in an RJ11 connector is correctly connected
and set.
Check the equipment POTS interface configuration: Menu >> Advanced >> Modules
Config. >> [R] or [L]: Slot POTS (depending on the slot into which this additional
module has been physically inserted).
Associate the POTS interface to the Program or
Coordination
channel
over
which
the
communication will be established: “Select
interface” in the channel basic configuration
menu.
Check communication interface status: blue
background must be shown in the corresponding
indicator in the up-left (Program) or up-right
(Coord.) corner on the TFT screen.
Select the enconding mode: “Sel. codec" in the
channel basic configuration menu. The available
modes vary according to the selected channel
(see section 1.3).
Select the communication destination (by
manually introducing the number or by selecting a
contact from the phone book): “Call to” and
“Select contact”/”Enter number” in the channel
basic configuration menu.
69
AEQ PHOENIX MOBILE