1
Download MX Series Programming Manual
Transcript
AMETEK Programmable Power 4.5 Array Measurement Subsystem MX Series SCPI Programming Manual [3Pi Controller Only] This command subsystem lets you retrieve arrays containing measurement data. Only current and voltage measurements are stored in an array. Two measurement commands are available: MEASure and FETCh. A MEASure command triggers the acquisition of new data before returning the readings from the array. A FETCh command returns previously acquired data from the array. Individual outputs of a three-phase source are specified by the setting of INSTrument:NSELect. Subsystem Syntax MEASure | FETCh :ARRay :CURRent [:DC]? :HARMonic [:AMPLitude]? :PHASe? :MODE :VOLTage [:DC]? :HARMonic [:AMPLitude]? :PHASe? 54 Returns the digitized instantaneous current Returns amplitudes of the first 50 harmonics Returns phase angles of the first 50 harmonics Selects waveform data transfer format Returns the digitized instantaneous voltage Returns amplitudes of the first 50 harmonics Returns phase angles of the first 50 harmonics MX Series
